Researchers at RTI International have developed a new solar power technology that will make solar energy much more affordable has been developed by researchers at RTI International. This breakthrough in low-cost high-efficiency solar energy should greatly help to speed-up its market adoption.
The new solar cells are created from “solutions of semiconductor particles, known as colloidal quantum dots, and can have a power conversion efficiency that is competitive to traditional cells at a fraction of the cost.”
Solar power has great potential as a renewable, carbon-neutral source of energy, but as of now their high cost of has slowed their widespread adoption.
The “RTI-developed solar cells were created using low-cost materials and processing techniques that reduce the primary costs of photovoltaic production, including materials, capital infrastructure and energy associated with manufacturing.”
A preliminary analysis of the material costs of this new technology has shown that it should be possible to produce it for less than $20 per square meter, that’s nearly 75 percent less than conventional solar power cells.
“Solar energy currently represents less than 1 percent of percent of the global energy supply, and substantial reductions in material and production costs of photovoltaics are necessary to increase the use of solar power,” said Ethan Klem, a research scientist at RTI and co-principal investigator of the project. “This technology addresses each of the major cost drivers of photovoltaics and could go a long way in helping achieve that goal.”
In tests done by the researchers, the solar cells consistently created a power conversion efficiency of more than 5 percent. That is very comparable to other promising and emerging solar power technologies.
“The efficiency of these devices is primarily limited by the amount of sunlight that is absorbed,” said Jay Lewis, a senior research scientist at RTI and the project’s other principal investigator. “There are many well-known techniques to enhance absorption, which suggests that the performance can increase substantially.”
The solar cells are composed of flexible, lightweight layers. These can be manufactured using ‘high volume roll-to-roll processing and inexpensive coating processes,’ this reduces the capital costs and greatly increases production. And in a great improvement over conventional solar cells, the new cells can be created at room temperature, this will greatly reduce input energy requirements and cost.
Another key benefit of the technology besides its low cost is its higher infrared sensitivity, this allows the cells to use more of the available solar spectrum for power generation. Not enough to make use of solar flares yet though.
The research on the new technology was just published in the journal Applied Physics Letters.
Source: RTI International
Image Credits: RTI International
For the fate of the sons of men and the fate of beasts is the same; as one dies, so dies the other. They all have the same breath, and man has no advantage over the beasts; for all is vanity. - Ecclesiastes 3:19